Chip.Haus — news and information on integrated circuits and other electronics
WM W600 Arduino (Development Board & Arduino Shield)
Note: The following information reported below is based on initial documentation from Winner Micro and may be subject to change. Once we have this board in-hand, more substantive and concrete information will be posted.
The WM W600 Arduino (a.k.a. "W600_EV BOARD_V1.0") by Winner Micro is an evaluation/development board based around the W600 Wi-Fi system-on-chip; designed for use as either a stand-alone board or as a shield board to be mounted on an Arduino Uno pinout compatible host.
- Identity
- Maker: Winner Micro
- Model: WM W600 Arduino (also written as "WM_W600_Arduino")
- PCB label: "W600_EV BOARD_V1.0"
- Resources
Notable Components
- System-on-chip: Winner Micro W600 [U1]
- Processor core: ARM Cortex-M3 up to 80 MHz
- Flash memory: 1 MiB
- SRAM: 288 KiB (160 KiB available for user program, 128 KiB used for Wi-Fi)
- Peripheral interface support including UART, SPI, SDIO, PWM, I2S, I2C
- 2.4 GHz Wi-Fi (IEEE 802.11b/g/n) support
- Crystal oscillator
- USB-to-serial
- UART0: WCH CH340E [U3]
- UART1: WCH CH240E [U5]
- LDO power supply
- Antenna
- Built-in inverted F-antenna (PCB trace)
- U.FL compatible connector for external antenna attachment
- USB
- Micro USB receptacle [J1] to CH340E [U3] for UART0
- Micro USB receptacle [J2] to CH340E [U5] for UART1
- Headers
- 8 pin male [CN1]
- 6 pin male [CN2]
- SPI & HSPI, 10 pin female [CN3]
- 8 pin male, [CN4]
- UART1, 6 pin male [CN5]
- UART1, 2 pin female [CN11]
- I2S master & I2C, 6 pin male [CN6]
- I2S slave, 3 pin female [CN8]
- PWM, 5 pin female [CN7]
- Serial Wire Debug (SWD), 2 pin male [CN9]
- SIM, 5 pin female [CN12]
- Switches
- Reset [SW1]
- User [SW2]
- Boot [SW3]
- Switch pack (3 switches) [K1] to RGB LED
- LEDs
- Multi-color red/green/blue [LED1]
- Power-on indicator [D1]